Re: aluminum spinner - ACS SN-4?


steve <sham@...>
 

Jim, Where did you buy your Rulon. Do they make bushings or did you fabricate yours?

Steve Ham

----- Original Message -----
From: Jim Patillo
To: Q-LIST@yahoogroups.com
Sent: Thursday, January 12, 2006 12:31 PM
Subject: [Q-LIST] Re: aluminum spinner - ACS SN-4?


Sam,

FYI, I've been using an aluminum spinner, aluminum backing plate and
aluminum front bulkhead (wrapped with small diameter black rubber fuel
hose)for 700+ hours now and have never had a problem. The front
bulkhead/rubber hose to spinner is a fairly snug push on fit.

Regards,

Jim P.

P.S. I've now converted the outer bushings on my ailerons and elevators
from steel on steel bushings(factory)to Rulon on steel. It completely
eliminated the up/down slop found on most all Q's. The controls are
extremely smooth. I will keep everyone informed as I complete a 1 yr.
test period.


-- In Q-LIST@yahoogroups.com, shoskins@m... wrote:
>
> Apparently the plate/tubing combination was not rock solid and some
movement
> occurred. This movement flexes the back plate and develops cracks.
The cracks
> appear as very thin black lines on the backplate, often around the
> circumference of the crankshaft flange.
> Sam
>
>
>
>
>
>
>






Quickie Builders Association WEB site
http://www.quickiebuilders.org





SPONSORED LINKS Aviation maintenance Aviation maintenance training Aviation maintenance schools
Aviation maintenance schools Aviation Aviation art


------------------------------------------------------------------------------
YAHOO! GROUPS LINKS

a.. Visit your group "Q-LIST" on the web.

b.. To unsubscribe from this group, send an email to:
Q-LIST-unsubscribe@yahoogroups.com

c.. Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service.


------------------------------------------------------------------------------

Join main@Q-List.groups.io to automatically receive all group messages.