Re: Slight Damage to Canopy


Mike Steinsland
 

I've been in autobody all my life.
Go with the flox, bondo will just break off the edge.

On Wed, Nov 11, 2020 at 10:57 PM Sam Hoskins <sam.hoskins@...> wrote:
Something that small and non-structural I would use JB Weld.

Sam 

On Wed, Nov 11, 2020, 9:30 PM One Sky Dog via groups.io <Oneskydog=aol.com@groups.io> wrote:
No bondo over epoxy It will come off.

Charlie


On Nov 11, 2020, at 6:44 PM, Jay Scheevel <jay@...> wrote:

I would just use bondo, then sand it down flush, paint it with some matching white urethane (just use a brush and do several coats 20 minutes or so apart). Wait for it to thoroughly dry, then go at it feathering it with 400, 800, 1200 grit wet sanding without working through the paint, then buff it and wax it and you are done. If you get through the paint, then just repeat the process. My 2 cents
Cheers,
Jay
-----Original Message-----
From: main@Q-List.groups.io <main@Q-List.groups.io> On Behalf Of Corbin via groups.io
Sent: Wednesday, November 11, 2020 6:18 PM
To: main@Q-List.groups.io Group Moderators <main@q-list.groups.io>
Subject: [Q-List] Slight Damage to Canopy

What’s the recommended fix for this bit of damage to the canopy edge?  I’m only assuming my avionics guy left something hanging out of the cockpit and then shut the canopy.  But it wasn’t there the last time I flew for certain.






Corbin

--
Corbin
N33QR













--
 
Mike Steinsland

Join main@Q-List.groups.io to automatically receive all group messages.