Found an interesting product that is even cheaper and does the same thing.

The pictures show how to use the product

https://www.amazon.ca/Blackjack-Guide-Coat-200-Grams/dp/B0181RKMLA/ref=asc_df_B0181RKMLA/?tag=googleshopc0c-20&linkCode=df0&hvadid=292872381981&hvpos=&hvnetw=g&hvrand=1047551339076463661&hvpone=&hvptwo=&hvqmt=&hvdev=c&hvdvcmdl=&hvlocint=&hvlocphy=9001117&hvtargid=pla-761995084992&psc=1

Cheers

Building my GU Vdub Q2

On Sat, Jan 16, 2021 at 10:13 PM Mike Steinsland <mikeskustoms@...> wrote:

I usually start with a coarser paper, 80 - 120 just to take the "crust" off then hit it with a guide coat again and progressively move up to a finer paper.

If you go through the primer STOP (unless it's your filler)

3M makes a charcoal guide coat that I have used for years.

Here's an amazon link but you should be able to get it through your local jobber a lot cheaper

https://www.amazon.ca/3M-05861-Guide-Cartridge-Applicator/dp/B000PENEMM

You put it on with a sponge like applicator (it's part of the the lid top)  You don't have to put it on heavy, a very light coat will give you all the contrast you need.

1 container will easily do your airplane

Nice thing with this is you don't get stinky paint fumes and overspray

On Sat, Jan 16, 2021 at 8:21 PM Dorothea Keats <dkeats@...> wrote:

  Good tip Mike.  I use a two foot board mostly and a sanding block
along with a trouble light to look for lows and highs. I'll give the
light misting of black paint a try.  I put the primmer on with a roller
. I  have premarked  with a pencil any low spots I can feel with my
hand. The prime I use I have mixed with micro so I lay it on thick in
the low spots. Board sand it later. Your suggestion will make it all
that much better.   Take care---------------  Chris


--
This email has been checked for viruses by Avast antivirus software.
https://www.avast.com/antivirus

--

 

Mike Steinsland

mikeskustoms@... 

--

 

Mike Steinsland

mikeskustoms@...