Re: Q1 Fuselage comes up


Bruce Crain
 

Nice Eugen!!  Can’t wait to see the finished product and hear your percent weight loss at empty weight!!
Bruce


On May 15, 2021, at 5:37 AM, Eugen Pilarski <interbus@...> wrote:

So far the bottom is in the bag for the next 24h!

<image1.jpeg>
<image2.jpeg>
 



Best regards Eugen 




Von meinem iPhone gesendet

Am 24.04.2021 um 16:18 schrieb Eugen Pilarski <interbus@...>:

Hello Q-Community,

so far the second fuselage side is in the bag.
😀

Please find below the picture.

Best regards 

Eugen 
<image0.jpeg>




From: main@Q-List.groups.io <main@Q-List.groups.io> on behalf of Eugen Pilarski <interbus@...>
Sent: Wednesday, April 7, 2021 11:58:41 AM
To: main@q-list.groups.io <main@Q-List.groups.io>
Subject: Re: [Q-List] Q1 Fuselage comes up
 
Dear Q-Community,

thanks for your hints and comments. Again, great to get that feedback from you guys! 

To post cure the Resin that I use for the Q1 Project (MGS LR385/LH386) it’s already a oven available that is used for the ASSO X-RAY Project (MGS LR285/LH285), please find below some Picture. It´s a full control heating process with some thermocouples and a customizing software solution (DIY).

It’s a easy construction of XPS elements, some cheap fans (Ebay 8$), two control cabinet heater from EBM Pabst (Ebay 20$), some bulbs (5 * 200W) and in the end a customizing fermentation controller (BrewiPI), please find below the link. https://www.brewpiremix.com   After all my aircrafts are in the air, maybe I will start to made my own beer :-)

To fit all parts of the Q1 in that oven it will be needed an extended version, if my buddy isn’t ready to go with his paint booth. So we will see……

The temperature will not rise more than 65°C, based on the Foam used in wing and canard area, for min. 15h but heat up 10°C/h (5h) and cool down with 10°C/h (5h).

So far all bulkheads are ready to go, just the seat bulkhead need to heat up (bending area) and fixed with resin/glass combo. The next step will be to contouring/cut out the bottom


Join main@Q-List.groups.io to automatically receive all group messages.