I have a few questions which have come up during my completion…
1) Stick extension - I have noticed on the Q tours (thanks for those Sam and all) that some have the extension on the front of the stick and some don’t. I can see it in the LS1 plans. My Tri-Q200 with LS1 (dual elevator rods) doesn’t have this, the previous owner says it meets the control throw limits, but I have it in bits at the minute and didn’t check. Why was this mod introduced? (Avoids having to cut a tunnel into the tank?)
2) Tail cone bolts - again in the tours I see some have the per plans dome headed screws and some you can’t see, have people fitting countersunk machine screws instead and filled over the heads?
3) My nose leg has a phenolic disc (adjusts deck angle?) plain washers and then 4-5 ‘cupped’ washers. I can’t see reference to this assembly in the plans, should I have this number of the cup washer or just one each side of the gear, I assume these allow you to preload the assembly without clamping down on it too much.
Thanks for reading! Tim