Am 13.06.2021 um 22:34 schrieb David J. Gall <David@...>:



“I did not catch up that point yet.”

 

I’m not sure I understand your reply. To clarify my point: plans page 4-3 comes before plans chapter 7 so glassing the firewall should have been completed before fuselage assembly. The instruction to do so is not explicit, but implied by the last line of text on page 4-3.

 

<image002.png>

I don’t think it will affect structural integrity to glass the firewall after fuselage assembly but it will only get more difficult to rectify this omission the farther you progress without doing so.

 

 

 

From: main@Q-List.groups.io <main@Q-List.groups.io> On Behalf Of Eugen Pilarski
Sent: Sunday, June 13, 2021 12:55 PM
To: main@q-list.groups.io
Subject: Re: [Q-List] Q1 Fuselage comes up

 

David,

thank you for your note, I did not catch up that point yet. 

Von meinem iPhone gesendet

Am 13.06.2021 um 21:42 schrieb David J. Gall <David@...>:



Eugen, aren’t you supposed to have 1 ply BID on each side of the firewall before fuselage assembly? See plans page 4-3.

 

From: main@Q-List.groups.io <main@Q-List.groups.io> On Behalf Of Eugen Pilarski
Sent: Sunday, June 13, 2021 12:19 PM
To: main@q-list.groups.io
Subject: Re: [Q-List] Q1 Fuselage comes up

 

Hello Q-Community,

 

Today I start to sand the unique Q1 lines, please find the progress below.

 

Best regards 

 

Eugen 

 

<image001.jpg>

<image002.jpg>

<image003.jpg>

<image004.jpg>

 

Von meinem iPhone gesendet

Am 08.06.2021 um 00:16 schrieb Jay Scheevel <jay@...>:



Very nice work, Eugen. I hope that Burt Rutan gets to see your final product.

 

Cheers,

Jay

 

From: main@Q-List.groups.io <main@Q-List.groups.io> On Behalf Of Eugen Pilarski
Sent: Monday, June 07, 2021 3:47 PM
To: main@Q-List.groups.io
Subject: Re: [Q-List] Q1 Fuselage comes up

 

Dear Q-list Group,

 

the Q1 fuselage assembly progress is stil on going, the last bulkhead 110 is on his place. So the next step will curve the outside of the fuselage to create the unique Q1 lines. Please find a link to my website, scroll down a liltle bit to reach the picture.

 

https://aerobase.weebly.com/q1-part-production.html   

 

During the whole progress I learn tons of stuff about foam, glass, resin, squeegee, flox, wet / dry / flush micro, vacuum bags and where my fingers should do not touch if sealing is placed and use all times a hat and much more ……………..what a wonderful journey :-) 

 

Thank you guys that you kick me in that path :-) 

 

Best regards

 

Eugen