Re: 0200 Engine

Richard Thomson

    Hi Jim

    There is an oil gallery on the face that is about 1/8th inch diameter. I used some PRC on an 1/8 countersink rivet to seal it off. had no leaks on my plate at all.

    Rich T

On 21/12/2021 03:45, Bruce Crain wrote:

Say Jim an A and P used a “wicking lock tight” at the outside of the crank case halves in the split.  I had not been able to get this area to seal the oil seep.  
I also used several 8 x 11 sheets of sand paper laid flat to “surface” the metal covere that replaced the suction pump when removed.  Cleared up most all of the oil seeps and things are now dry after several years.
Bruce Crain

On Dec 20, 2021, at 7:54 PM, Jim Patillo <logistics_engineering@...> wrote:

Thanks guys. Mike N. Directed me to one. 


From: <> on behalf of Kevin Sheeley via <kjsheely1@...>
Sent: Monday, December 20, 2021 5:28:55 PM
To: <>
Subject: Re: [Q-List] 0200 Engine
I did the same as Mike. Use the gasket as a template.

On Monday, December 20, 2021, 8:19:19 PM EST, Mike Dwyer <q200pilot@...> wrote:

I think I just built one out of 1/4" AL.  Back before CAD so don't ask for a drawing!
Mike Dwyer Q200

Q200 Website:

On Mon, Dec 20, 2021 at 8:15 PM Jim Patillo <Logistics_engineering@...> wrote:
Does anyone have an 0200 vacuum pump cover they would part with? I'm finally getting rid of about 30 lbs. of vacuum stuff. 


Join to automatically receive all group messages.