On May 14, 2022, at 10:10 AM, Mike via groups.io <n7000t@...> wrote:

Nice job Jim!!!!

Mike 

On May 14, 2022, at 11:48 AM, Rick Hole via groups.io <r.hole@...> wrote:



Just a reminder, wire size for both power and ground is determined by the breaker or fuse protecting that circuit, not by the expected load. 

In the event of a short circuit the wire must conduct high current until the breaker or fuse interrupts the circuit without overheating.

For an extreme example, consider if the load were a 10 mA LED pilot light connected to a 10 amp breaker circuit.  A short at the LED would result in (more than) 10 amps flowing through the wire.   While it is tempting to think we could use perhaps a 24 or 26 gauge wire, plenty good for 10 mA, that wire would glow red hot before evaporating with the possibility of causing other nearby wires’ insulation to melt and a cascade failure result.  Or an in-flight fire.  Hence the wire must hold up for the trip current long enough for the breaker/fuse to blow.

 

Rick Hole

 

From: main@Q-List.groups.io [mailto:main@Q-List.groups.io] On Behalf Of Kevin Boddicker
Sent: Saturday, May 14, 2022 10:11 AM
To: main@q-list.groups.io
Subject: Re: [Q-List] AV30 Install

 

Jim,

What size wire did you use for the install?

 

Will I see you in September? No song lyrics intended.

 

 

Kevin Boddicker
TriQ 200 N7868B  580  hrs
Luana, IA.