toggle quoted message
Show quoted text
Brad Olsen and I made a trip back from OSH to Bay Area at 14,500’ over the mountains.
Later that year, I got a clearance and vectors from Nor Cal to “ test climb”. The plane was hanging on the prop at 19,500’ with no more poop. It was just very mushy. The trip up was nominally 500-750 fpm. My 0200 with
9:4.1 pistons and dual Plasma 3 Lightspeed Ignitions felt fairly normal.
Funnily side note; a SW737 passed off my right side close up (opposite direction, headed to SFO) at about 19k and I’ve often wondered if a kid may have been looking out the window and said mommy, mommy a giant
bird just flew by AND she said ok just sit down, be quiet and fasten your seat belt.
From: main@Q-List.groups.io <main@Q-List.groups.io> on behalf of Mike Dwyer <q200pilot@...>
Sent: Tuesday, October 18, 2022 4:33:08 PM
To: email@example.com <firstname.lastname@example.org>
Subject: Re: EXT :Re: [Q-List] Q2 down
I used to operate my Q200 at 12 to 14,500 feet, probably density altitudes at least 2000 feet higher than that with no issue seen. Typically using no ethanol auto gas. I had 500 fpm climb rate left at 14,000 ft. MA3SPA carb.
Mike Dwyer xQ200
On Tue, Oct 18, 2022, 14:25 Kidd, Robert L [US] (IS) <robert.kidd@...
I found your post to be very interesting.
Sunday afternoon I was returning to Logan Utah from Halfway Oregon, in a Cessna 150. Was cruising along at 9,500 MSL, leaned and throttled back slightly. I attempted to climb higher to clear some terrain and at about 10k’ my engine
stumbled and began to run rough. I pulled the carb heat on and it cleaned up momentarily before it continued to run rough, so full rich mixture added kept it stumbling along. I have experienced this before when running Mogas, and thought I had cured the
problem with a replacement fuel line between my gascolator and the carb, and installing firesleeve over that fuel line. I’ve been able to fly to 10,500 without issues, and this time I had a mix of Mogas and Avgas (about a 5:8 ratio), and was surprised to
once again experience symptoms of vapor locking. I was almost over Idaho City (U98) and debated landing but opted to turn south to lower terrain. Full carb heat, full rich carb mix, and occasionally having to pump the throttle to keep it running, I descended
to about 6700’, skirting the east corner of Boise’s airspace, before it started to run reasonably. I was able to adjust the mixture, but still had to maintain the carb heat setting as I made my way to Gooding for a fuel stop. As I closed in on Gooding,
I was able to adjust the carb heat off. After I landed at Gooding and fueled up, the rest of the flight home was uneventful, even when I climbed back up to 9,500’.
I’ve never had an issue when I’ve run straight Avgas, and thought I had enough Avgas that I couldn’t have any issues with the mixture of Mogas I was running, but maybe somebody’s chemistry changed, or some other reason that I haven’t
worked out yet. I’ve wondered about installing a fuel pump somewhere in the system, to turn on when this event happens. I don’t suppose most of the Cessna 150’s are operating at these altitudes. Perhaps something similar happened to the Q2 that went down
Thanks for sharing your insights.
Not to get too far over my skis here, but when I did the comprehensive summary of Q accident statistics (http://n8wq.scheevel.com/documents/Quickie
Type Aircraft Accident Analysis.pdf ), I found that the number one cause of engine failure was actually a failure in fuel delivery (Fuel starvation due to fuel delivery problem or fuel exhaustion). This is not unlike the statistics in homebuilts in general,
so is important even if not building a Q.
I have tested my fuel delivery system’s reliability from near sea level to 18,000 feet. I find that my system does behave differently depending on altitude. By this, I mean not just mixture and carburetion, but flow through fuel lines,
pumps, induction air and regulator all behave differently. If you have not tested your fuel system for robust reliability at all altitudes within your altitude envelope, then caution is warranted as you expand the envelope, because the fuel flow may suddenly
So indirectly, going to your original question, your engine-altitude performance may be a complicating issue, because in high terrain, you may not be able to maintain sufficient AGL to glide to a safe landing area if an engine problem
Jay I agree we are just curious what happens to learn from that! In my case I'm still rebuilding my Quickie and never flew one before and want to learn!
On Tue, Oct 18, 2022 at 10:21 AM Jay Scheevel <jay@...> wrote:
Looks like the engine was not running, so I don’t think it was a performance question.
What I am saying, since the airplane is based in Vancouver, so that the pilot would have a lot to handle, first with the engine out, next with the density altitude that was likely over 11,000’, then with wind and possibly gusty wind.
Was a good landing, all of that considered.
My thought is that she went for the pavement, but probably broke the canard on the road and then veered off into the sage brush. Not a bad strategy, actually, given those conditions!
Also looks like new blacktop with a huge shoulder drop off.
Jay- are saying it was maybe above it’s max ceiling at 10,000MSL? And that may have caused the engine out? What is the max ceiling for a VW engine powered Q2 or Dfly?
On Oct 17, 2022, at 10:40 PM, Jay Scheevel <jay@...> wrote: