Re: Spinners

Bob Farnam <bfarnam@...>

I used 0.062 aluminum for mine. Incidentally, I first used Tygon vinyl for the tubing, but found that it began to cut through. I replaced it with poluurethane which has much higher cut and
abrasion resistance. It has been in place for about 300 hours with no sign of cutting.

Bob F.

James Patillo wrote:


I believe it was either .080 or .090. I sliced clear tubing, wrapped it around the spinner bulkhead and taped the two ends together with gray duct tape. Has worked well and does a great job.

Jim Patillo N46JP Q200
----- Original Message -----
From: David J. Gall
Sent: Sunday, May 26, 2002 10:11 PM
Subject: RE: [Q-LIST] Spinners

Ditto. Works well. Jim, what thickness aluminum did you use? I think we used
.090, but I can't remember.

David J. Gall

To unsubscribe from this group, send an email to:

Quickie Builders Association WEB site

Your use of Yahoo! Groups is subject to

Join to automatically receive all group messages.