So the 0-235 will work then, that is a great option but what about a mount ?? any ideas ?? Tom think it Behalf Of t=ms&k=Aviation+maintenance&w1=Aviation+mainte >

Brad, Could you please contact me at q2robertson@... Thanks Rene Q2 C-FBWV --------------------------------- Find your next car at Yahoo! Canada Autos

I know of at least one guy, in Canada, that installed an O-235 I think it was a hot rod! I think an IO-240 would be real neat but a lot of $$$$$$$$$ Sam _____ From:

Is the Lycoming 0-235 or the Continental IO-240 an option to the O- 200 ?

That should read standard 72" not 64". Peter

SHHHH I knew that! I was taking a dig at Jim.He should of covered the prop for theatrical value if nothing else. Regards, Damian Gregory N8427 Q200

Leon , glad to hear it. I too have gotten a bit of repreive from wa wa wa work... first things first I am in the process of getting my body rebuilt.( n0 not cosmetic) Got my shoulder fixed next is my

Hi All, If this topic has been discussed to death before, please shut me up and I'll go dig through the archives. I mentioned recently that I need to replace my prop on my Subaru EA82 powered

Dawie I am using a warp Drive three blades 60" but because of a 3:1 gearbox I am set at 24deg pitch that is a lot of pitch. I think you will find Warp Drive standard dia is 64" and you cut it down to

Look on Jim's plane. He stole Paul's prop. Pat

Maybe this week............ I finally got a job that not only gives me the money needed - but also gives me blocks of days off so I can actually get things done. I'm getting caught up on about 6

ONE Problem with pics. Paul Lipps does not have a prop. Regards, Damian Gregory N8427 Q200

Thanks , David . I think I am just going to bite the bullet and go for 3'X 18' to make sure I can get pants over jig table I have Postma"s canard to fix as well as building a new one.

Leon ,thanks any progress on the Marske style spar test? Regards, Damian Gregory N8427 Q200

Come to think of it, this comment applies to all of the "Q" guys at LVK. --- Mark Robinson <secondfork@...>

I did 3' x 17'. The extra foot of particle board from the long sides of the 4x8 sheet went to tabletop for the last 1x3 section of the table, and the remaining 1x8 and 1x5 pieces make dandy shelves.

smidude@...

hgflier@... Bob F. N200QK EAA Flight Advisor

Anybody know Geoff Rutledge's email address??? Doug "Hawkeye" Humble www.asignabove.net Omaha NE N25974

My table is 24" X 16'. I like the width but if I had it to do over I'd make it at least 17' long........... I laid particle board over my old rotor blade table which is very stiff and can be twisted