You guys need to be careful about "picking at your bumps". I started doing this 14 months ago and I have been in the process of COMPLETLY stripping and refinishing my plane. I thought I did a good job

The Q-200 POH is just the Q-2 POH with a four page supplement that gives weight and balance and performance specs of the factory airplane. The supplement info is also in QAC newsletter 20. Mike

No Q-200 POH to my knowledge. Doug "Hawkeye" Humble A Sign Above www.asignabove.net Omaha NE N25974

Hi. It's funny how these subjects come up. I was picking at some cracked paint on the coaming of my a/c last night and it just started flaking off right down to the fibreglass. I am carefully using a

Richard, I have my sparrow strainers mounted just behind the middle hinge support of the elevator, as indicated on plans. I asked the same question this fall, because I noticed most Q2/200 have

You need the UV barrier, remember Gore says the Ozone is gone and you don't want your plane melting in the hot sun. Also the paint that peeled off mine was also black on the bottom. I don't think it

Thanks for the tip. I am using PPG DP90LF two part black primer. Since it is also a UV barrier and is appropriate for PPG finish coats, I will be using it as the final primer. Hopefully, I will

Mine are also close to the fuselage. I did it cause thats how the factory plane was, also gives the least adverse yaw, which couldn't be much. Mike N3QP Sam Hoskins wrote:

Doug Is there a Q-200 POH also? Peter _____ From: Q-LIST@... [mailto:Q-LIST@...] On Behalf Of Doug Humble Sent: Monday, 26 February 2007 12:45 AM To:

Yes, mine are close to the fuselage. I don't remember why they are there, since I installed them about 22 years ago. Anyone else? Sam Hoskins Murphysboro, IL _____ From:

Sam H, Was I dreaming, or are your sparrow strainers fairly close to the root end. Mine are in the middle, so what is the thinking behind it ? Does it matter where they are ? Richard Thomson TriQ

Joseph, One tip that I saw on the Canard Aviators site from Ken Miller I believe, was if you are using epoxy primer add some dry micro in any pin holes or small defects as you paint. It bonds tight

Hi All, I had dealt with all the bumps that had been there on the tail cone before Xmas, so after the cold spell began to lift back in mid Jan, I looked to get things ready to start priming. I started

I have the Q-2 manual in a zip file, opens into a .doc file which opens fine in WordPerfect and I suppose in Microsoft Word as well (never tried). I also have the Quickie (Q-1) manual as a .pdf. I

I am really sorry about not getting this link correct. Try this one: http://corvairq.info/Microfiller.htm Joseph

OOps! The previous email had a misspelling in the link. Sorry about that. Here is a link updating my progress on N240JS. It is about Microfinishing. www.corvairq.info/Microfiller.htm Joseph

Here is a link updating my progress on N240JS. It is about Microfinishing. www.corvairq.info/Microfiller.htm Joseph Snow

In a message dated 2/25/2007 4:21:49 P.M. Eastern Standard Time, shoskins@... writes: Yes, mine are close to the fuselage. I don't remember why they are there, since I installed them about

I do work for an italian company in the aerospace field and will be in the US for a business trip in the next days. I cannot claim anymore being a Q1 builder , since I never completed the airplane. I

I just downloaded the pdf from John's site and I'll put it out at the QBA site soon. Good to have it in a couple of places anyway. Doug "Hawkeye" Humble A Sign Above www.asignabove.net Omaha