Dave What the heck is a "gozintas" session?

This maybe a very dumb question, Is there a 4-seater Q2? Has anyone tried to modify the two place to a four place? I saw where someone had put retrac gear on their Q2, so why no a four place?

Dave, Wouldn't that be a useless number anyway? After all, with such variation in the way each airplane is built and the large effect that even small changes can have on such a clean airframe, I

Hi Larry, It is the standard overhead projector material. I would guess it is about .003-.004" thick. I used 100% silicon caulk (clear,thick stuff). To apply the caulk I used tweezers to hold

I worked out roll-rates for different speeds on my Q1 and posted these last year. Suggest you check the archives. Cheers, Paul Dave King <KingDWS@...> on 09/23/2000 11:38:11 PM Please

Just wondering if anyone has run across a published figure for the flat plate area on a Q1. I did a "gozintas" session and came up with a number of 1.05 square feet. Any ideas, guess's etc? Dave

Ed You have any idea how thick this Mylar is? How did you stick then on? Larry

Hi Dave, If you have a PPG paint dealer in town get some DX330 Solvent, it'll remove silicone based chemicals and won't have any effect on the foam core. Use two clean rags, one to apply small amounts

Honestly, every year it's something with you, Terry! I'm only kidding. You are doing the right thing. Don't push it too hard. If it was meant to be ready for Ottawa you wouldn't have run into

Sorry T, Guess you'll have ta' buy da' movie. Hey, kin' I have yer extra meal. I wanted to get 1st dibs afor' Jimmeh or some one thunk of it. Wish you could make it but I understand. Paul F. and I

T: I applaud your ability to error on the side of safety. It is totally the right decision. It isn't worth breaking something. However, it truly is unfortunate that you won't make it to Ottawa this

Greetings All, Just a plug for Jeff Russell. I'm still using EZpoxy as I've got one of those gee whiz epoxy pumps that works with that and it's great in humid areas. Wick's and AS quit selling

Thanks folks for all your help. This really demonstrates the power of this Q-List tool. Back to sanding...

Has anyone tried overhead projector sheet (Mylar?) for VG material? I mounted them but have not flown with them yet, let me know if it is a bad idea. They are very, very easy. You print the

In a message dated 9/25/00 5:27:21 PM Mountain Daylight Time, n1victor@... writes: << Hi Dave, If you have a PPG paint dealer in town get some DX330 Solvent, it'll remove silicone based

Jon Finley wrote: Jon, thanks for giving me the big head. I am no authority but I have seen enough and built enough to learn a little. Back around 1986 I purchased a set of Co-Z plans for the 3

Ottawa bound Q-Guys, This weekend, I came to the rude realization that my flight to Ottawa in my Q-200 is not going to happen. While final machining the rocker arm shaft bosses on the number two

Wow!! When did you join us Jeff?? I had no idea we such an authority among us!! Welcome and please jump in as often as time permits! For those that don't know Jeff has been in the composite world

Dave Richardson wrote: <snip> If it was WD40, the grease could be down to the glass and must be removed before anything will quit leaching it to the paint. 1) Sand the micro down to the glass. 2)

"Michael D. Callahan" wrote: ...then there's the issues of any chemicals leaching in and attacking the foam core. Pat