Eugen, I was talking with Boddicker about your pictures. Looking at the picture of your wing it appears you do not have the shear web glassed in. From the picture of the end of the wing it appears

Bewdy Chris ... Progress sounds great .. thanks for the updates..., ............ Graham -------------------------------------------------- Sent: Saturday, July 16, 2022 9:07 PM To:

Thank you Mike. VERY helpful. Jm

Jim-----------------  I would like to remove the gascolator, but the  "rules" in Canada make it mandatory.  Because on my application I have fuel that moves back to the header, there isn't much

Hello Q-Community, What type of material is used for the tail wheel support? It’s a rod of 1.4310 (x10CrNi18-8) in US 301 (UNS S30100)? Which wheel diameter on the tail wheel would you recommend?

Just curious, Is there a Quickie gathering planned during AirVenture as there has been in the past. Thanks Keith

Hi Chris, I would suggest throwing that gascolator as far away from your Quickie as you can. It’s another source of vapor lock. I’ve never found any water in my fuel. Several of us have removed

Back in 1985 when I bought the rebuilt 0-200A for $3500 I had 30 PSI at 210F with W100 = 50 weight oil. At idle it would only drop to 25 or so. 36 years later at 150F I'd see 30 at best and 10 at

Thx Paul. Mine is similar to yours, except about 5psi less. I'm thinking mine never has been 40. Maybe I just woke up. Now that I am awake I would feel more comfortable if it read 30+ at cruise.

Jay------------  On my injection unit the main supply to the gascolator  from the header is 3/8. Thats' the rule here in Canada , but the pumps, injector lines are all 5/16. So after the gascolator

Hi Kevin, I have a very small lady inside my EFIS that tells me over the intercom if there is an oil pressure problem. She lets me do the flying (most of the time), but she is very insistent when

Bruce, Any rpm at start will yield 40 psi. Sometimes it takes a while to move the needle. Usually during cold weather. The only time I see below 40 PSI is during taxi after landing. I don’t pay

Since you are changing them out anyway, Robert. Why not go to 3/8”? Nearly all aircraft have 3/8” lines now. This is what I have on my plane. Cheers, Jay

One at a time. Forgive me. I couldn't resist.

Kev and Dave, thx for your input. Kev, yours fit well within the specs. The Revmaster must have a very efficient oil passage way. Sam gave me an excellent reference. It appears that this is a common

Hi Jerry Rule of thumb with the Revmaster is 10 lbs PSI for every 1000 RPM. Example....2500 RPM / 25 PSI oil pressure.

Kevin will turning up the rpms at start up bring the oil pressure up? I have to do that if I haven’t flown in a month or so. Bruce

You made me look! Sorry for the delayed response Jerry, I have an old analog oil pressure gauge so I don't pay attention to the absolute value - I just verify the needle is in the correct position. I

Robert---------------  Make some plates from 3/8 aluminum and drill and tap to the proper size pipe thread.  Drill your hole in your header and then mark the aluminum fitting on the outside of the

In reading my instructions and talking with SDS, it turns out my 1/4 fuel tank outlets need to be at least 5/16. What's the easiest way to replace them? Thanks Robert -- Robert "TheFrisco"