Peter, It is SAE-1 with lugs. Paul Spackman wrote: has 6 holes X 12mm dia X 100.00mm PCD and the holes will be fitted with spigots (lugs?) 12mm OD to fit into the prop.ie the prop fits onto the

Another question on the 0-200 engine performance does anyone have the power curve showing hosepower and torque vs rpm? Peter

Peter, State where it is right or left hand turning (from pilot's position) and if it's SAE 1, lugs or no lugs. David afford for a Q-200 powered by Jabiru 3300. I think maybe 60x72 or 58X72. Still

Paul that ties in with advice from Ed Sterba but Jabiru told me SAE1 would be a special order and they have sent me a Dwg showing 100PCDX12mm holes OR 101.6PCDX14mm holes. SAE1 is what I wanted ! I

sounds like you lots into yours. My kit has been 50% built by another person so i do have lots of work but at least i am not starting from scratch. One bad thing though is trying to find out where

Peter, I didn't see what prop you were looking for? Is it a Rev or 0-200? I might be able to help. David Hiatt Seattle how about the Ed sterba wood prop for $500 ? Is there any feedback favourable

Wes, You may want to take a look at N46JP sitting next you. I found the axles tubes to weak right away and replaced them with thicker wall aluminum. I then machined and installed stainless through

Wes, you are right to replace the aluminum axles. They do bend. I like the idea of titanium, but since I don't have the budget of a B-2 bomber, I just used 4130 steel. Same wall thickness. Never

Anyone have thoughts, experience, or suppliers of titanium axles? Or care to buy in bulk for $40 each? Other reasonable alternatives? I'm replacing my aluminum axles. To avoid corrosion when using

David it is RH rotation from the pilots view. The prop mount flange has 6 holes X 12mm dia X 100.00mm PCD and the holes will be fitted with spigots (lugs?) 12mm OD to fit into the prop.ie the prop

Doug, http://groups.yahoo.com/group/Q1_Aircraft/ Ryan

Hawkeye, It's called Q1_aircraft. Only q1's much smaller group. Less intimidating than full q group. I have photos in photos section "Dave R Q1". Regards, Dave R. Q1 Texas should canopy.

Q1_Aircraft@... DUG (Doug Tenney) Boise, ID

Thanks David. I am looking for the best cruise prop match I can afford for a Q-200 powered by Jabiru 3300. I think maybe 60x72 or 58X72. Still taking advice and waiting to hear from Ed Sterba. Hope

I was unaware of a "Q1 group". How does access it? Doug "Hawkeye" Humble www.asignabove.net Omaha NE N25974

Smooth, My q1 is getting a 60 Hp, Hexadyne Engine, should see it in two weeks. Putting on a custum made composite Price Aviation Prop, should have it this week. Intrument panel is not attached to the

Phil, Glad to hear you all are doing better. I am 10 weeks past cuff surgery and it is waaaay better. Hang in there with the PT. Regards, Damian Gregory N8427 Q200

Peter, No, I won't be the first to try it as I have been copying the formula 1 and biplanes from Reno. Out of all the plenums I have looked at I liked parts of LF's the best and did use some of his

Great work Ron. Now that I am starting over with an aircooled engine I have got a lot to learn again. A few years ago when researching air pumps for an exhaust extractor I found a good article by