Corbin, To make the fitting I just drilled a small hole in the screw that came with the master cylinder and epoxied a 1/2" of aluminum tubing to it to slide the plastic tubing over. Jerry

Thanks Richard. I think I will try this method again today. I would love to get a fitting like Jerry and connect to the reservoir to collect overflow. Maybe I can determine that size today and get

We use one of those old timey hand pump oil cans and attach it to the bleeder at the caliper. By back filling the system it only takes one person to do it and will push out any air in the system. If

I usually use a helper to pull on the brake while I man the bleed fitting. Also, a bottle like this makes filling a lot easier. ACM Economy Wash Bottle, LDPE, Squeeze Bottle Medical Label Tattoo

I have Matco breaks and have a terrible time bleeding them. Since the bleed port fitting at the caliper is not directly below where the brake line attaches, there is an air pocket that sometimes

Chasing some air in my brake lines. I tried a vacuum pump system but I don't think I could get a could seal from the pump itself. Then I tried pushing fluid using the oil can method; through the

My Quickie and Cozy both have fiberfax and stainless. Use aluminum for a template. Terry Crouch

Matthew I used fiberfax which was the name of the material supplied in the original kit. It was very delicate to work with and the plans called for aluminum sheet to protect it. Dave D Sent

There is a fireproof, water based glue that is for sale on Spruce. This is what I used to attach the fiber to the firewall. I also used that: Here is the link.

I have a thin sheet of stainless over fiber fax. It seems the fiber fax had some sort of a special glue to hold it in place. I don't remember what it was, maybe Liquid Firewall? In the mag box recess

I did precisely as you described. Satisfied. Fortunately, never been tested. jerry

Hi Matthew, I have done similar to what you are thinking (with ss), but put a piece of fiberfrax between the ss and the fiberglass firewall. Fiberfrax is the best insulator, in addition to the

Mine has stainless

Curious what you all have done for a firewall. My Q2 had some kind of fireproof fabric bonded to the firewall with no aluminum sheeting or anything over that. There was originally paint but that has

Oh, and you'll need some new ferrils. Take a piece of tubing to ACE hardware, they got them. Mike

I just got some off eBay. LINK Nylaflow Tubing Tube 3/16'' Type H High Pressure Pneumatic Mike N3QP Q200

Plus someone to fix up all those bleeding holes from safety wire!! :-)

I have the Airheart disc brakes and am wondering if anyone know the OD and ID size for replacing the tubing. Also, since there’s a chance my fitting is also in need of replacement; does anyone know