Riley and Wesley are Scott's sons. Sonia (1953-2020) & Rick

When Scott re-acquired his N1711Q I helped repair the tailbone and built a new instrument panel for it. Thanks for Rick Hole

Thanks Dave. I enjoyed your presentation Rick Hole

Test Rick Hole

The easiest is if you can pull back the center far enough then cut the armor with a cutoff wheel RICK Hole

It is quite pleasant to be of help. I have installed oodles of these and made all the mistakes in the first ones. Klaus is indeed a challenge and once in a while makes a human error but you will be ha

Your ignition module is providing 2 pulses per revolution (see page 43 of Plasma II/III installation manual). You would need to set the tach display for that. Probably it has been set by default to 1/

The tach display will have settings for various number of pulses per rev. When you get the right setting your RPM will be correct. It will never be just a bit off. Good luck. You are almost there!

Can you tell US how mucho higher? If for example it reads at 1.5x 2x etc it may be a setting on your tach display.

It is a hall sensor. I once replaced one which was sheared off by the magnet. Rick Hole

As you are planning inboard land gear, the strength required at the tip of the canard is much reduced. With the gear at the ends of the canard I would not touch a repaired spar under any circumstances

#photo-notice

I’ve seen this in Velocity installations. Granted I have been retired for 4 years so I may be a voice from the past. Be sure the ignition computer box is getting power and ground (I would measure it a

I have many a bunch of panels for both Velocity and Q. Computer designed panels are great but complicated to use. Another option is poster board full size with paper-doll style full sized instruments.

Nice job! Rick Hole

I second that. At Velocity we learned nit to out them there. When hot they would malfunction Rick Hole

In my Velocity days we would drill a small hole though the connector and lug and safety wire it. Rick Hole

I like Klaus' sensor. I've installed a bunch of the previous with a circuit board for the ring. That was a pain in the neck. Ulimately you need the sensor to align with the magnet at TDC and both magn

Both good. Thanks Rick Hole

Both messages arrived. I watched part of the video but was interrupted. looking forward to the rest of it. Well done! Rick Hole

For those who are using connectors not if thermocouple material: a difference in temperature on the two sides of the connection will induce an error. It will be equal on each sensor so for EGT the err