I have a TCM starter (654046), key/solenoid start, would that be what you refer to as a ‘Cessna’ starter? I guess I need to do some research on the different starters and the internals. Thanks, Tim

Happy new year Jay & all. Great picture!

Hi Mike (Dwyer), Can you offer some suggestions on the MA3SPA, I have to set mine up… I don’t have it to hand but I seem to recall the supplied instructions were a little light. Thanks, Tim

Thanks all, appreciated.

Managed to get the control rods the correct length today and then fit the spring pitch trim. I notice the elevator horns move about 1/2” relative to each other when rolling, I know the plans suggest t

Interested in what front tyre people are using on the Tri gear. Mine currently has a 10x 3.50 x 4 McReary Airtrac (https://www.lasaero.com/products/article/W006S408F) which is quite square in profile

Thanks Jay. So finally got to a point today where I had elevator control rods ready. It appears if they are fitted either side of the stick tube it creates excessive elevator movement when you roll… I

Hi Rich, I’m pretty sure it is 3/16” , but being at home now I can’t double check. Plans say AN3 I believe. Not yet on to elevator controls proper, still doing aileron bits. Tim

Hi Jay, Looks like it has the bush. Has been welded and ground flat on the outsides. Cheers, Tim

Thanks Jay - very helpful. Will see how it looks at the weekend.

Hi Sam, Hopefully the photo works, I mean the plate welded to the front of the tube. Thanks Bruce and Jay - I’ll have a look out for those plans and do a bit more research. Cheers, Tim

Hi All, I have a few questions which have come up during my completion… 1) Stick extension - I have noticed on the Q tours (thanks for those Sam and all) that some have the extension on the front of t

Worked the other month, following a bit of manual attention from Jon it then sent out the links for the downloads.

Hi Mike, I needed similar info for other metal parts and ended up buying the appendix for the plans from quickheads. It looks like EM2 is 0.125” in 2024T3, so you have the right spec. Cheers, Tim

Hi Bruce, The ones at the split of the tail cone. But I have since found the plans I was missing at quickheads.com and just need to have a read through. If you had the figures to hand that would be a

I was wondering if anyone has the dimensions for the rudder cable disconnect plates (FC2) and could let me know? The plans I have say refer to an annex for a template and ... I have no annex :-( Thank